INVITATION TO TENDER: Compressor Airlifting and Borehole Development Works for Ten (10) Village-Drilled Boreholes.

Background Samaritan’s Purse Liberia intends to engage a qualified drilling service provider to carry out compressor airlifting (blow-out) and borehole development works on ten (10) completed village-drilled boreholes. The purpose of the exercise is to remove drilling residues, fine sediments, clay particles, and other foreign materials from the boreholes; improve aquifer connectivity; increase borehole yield; and ensure that each borehole produces clear and sustainable water suitable for hand pump installation and community use. The Contractor shall provide all labor, equipment, compressor units, air hoses, fittings, transportation, fuel, personnel, tools, and incidental services necessary to complete the works in accordance with these specifications. Please read carefully the Technical Specifications/Scope of Work for compressor airlifting (Blow out) of Boreholes: Objective of the Assignment The objective of the airlifting exercise is to: Remove drilling mud, clay, silt, and fine particles remaining after drilling Develop the aquifer and improve water inflow into the borehole Increase borehole yield and recovery rate. Improve water clarity and quality Verify borehole depth and condition before hand pump installation Ensure the boreholes are ready for long-term operations. Scope of Work The contractor shall perform the following activities for each borehole: Mobilization The contractor shall: Mobilize compressor, accessories, hoses, tools, and personnel to site. Ensure all equipment is in good working condition before commencement Provide adequate fuel and lubricants throughout the exercise. Coordinate activities with Samaritan’s Purse’s Drilling Coordinator or Technical Officer Pre-Development Verification Before commencing airlifting operations, the Contractor shall: Measure and record total borehole Measure static water Measure casing Inspect the borehole Confirm that gravel packing and sanitary sealing have been completed where No airlifting work shall commence without the presence and approval of the Employer’s Drilling Coordinator or Technical Officer. Compressor Airlifting and Borehole Development The Contractor shall carry out borehole development using a high-capacity air compressor capable of delivering sufficient air pressure and volume to effectively clean and develop the borehole. The development process shall include: Lowering airline pipes to appropriate Conducting continuous airlifting Surging and agitation of water Removal of drilling residues and suspended Cleaning of borehole screens and intake zones Removal of accumulated sand, silt, clay, and cuttings. Development shall continue until: Water is visibly clear. Sand content is negligible No significant drilling residue is observed Water quality shows substantial improvement Borehole yield stabilizes Under no circumstances shall the Contractor stop development solely based on time allocation if the borehole remains inadequately developed. Minimum Development Requirements For each borehole, the Contractor shall: Conduct development for a minimum of two (2) continuous Continue beyond two hours whenever water remains turbid or sand content remains Ensure development is based on borehole performance rather than fixed The Employer’s Drilling Coordinator or Technical Officer reserves the right to require additional development if results are unsatisfactory. Removal of Sediments The Contractor shall ensure the complete removal of: Clay Drilling Fine Silt Organic Foreign objects introduced during Any borehole showing continued sediment production shall undergo additional development until acceptable conditions are achieved. Yield Observation During development, the Contractor shall: Observe borehole Estimate yield where Monitor recharge Record development Any abnormal borehole conditions shall be immediately reported to the Employer. Technical Requirements The Contractor shall provide: Compressor Minimum working pressure of 12 bar (175 psi) or Adequate air delivery capacity for borehole Reliable and well-maintained Airlifting Equipment High-pressure Airlifting Connectors and Discharge control Personnel At minimum: One experienced Drilling One Compressor Supporting Technicians/Laborers All personnel shall have proven experience in rural water supply borehole development. Quality Control Requirements The following minimum standards shall apply: Water Clarity The Contractor shall continue development until water appears substantially clear and free from visible suspended materials. Sand Content Water discharged shall contain minimal sand. Borehole Recovery The borehole shall demonstrate adequate recovery after development. Borehole Integrity The Contractor shall ensure that development activities do not damage: Borehole Screen Gravel Borehole Deliverables For each borehole, the Contractor shall submit: Borehole Development Record Including: Borehole Community GPS coordinates (if available). Initial Final Static water level Development start and end times Observed yield Remarks and recommendations Photographic Documentation The Contractor shall provide clear photographs showing: Site before Equipment Airlifting Discharge water during Final clear water Site after Photographs shall be shared electronically with the Employer’s Technical Officer on the same day of operation. Supervision and Reporting All activities shall be carried out under the supervision of the Employer’s Drilling Coordinator or Technical Officer. Daily progress updates shall be Any unforeseen condition requiring additional work shall be communicated immediately before action is taken. No variation work shall be undertaken without written approval. Health, Safety and Environmental Requirements The Contractor shall: Provide appropriate Personal Protective Equipment (PPE) to all Secure the work area during Prevent injury to community members Manage wastewater discharge to avoid erosion and flooding Prevent environmental contamination Maintain good housekeeping at all sites. Acceptance Criteria A borehole shall only be accepted when: Development has been completed to the satisfaction of the Water is substantially Sand production is Borehole depth has been verified and Required records and photographs have been No damage has occurred to the borehole Payment Conditions Payment shall be based on successful completion and acceptance of each borehole and shall be subject to: Submission of development Submission of photographic Verification by the Employer’s Drilling coordinator or Technical Acceptance of completed Failure to achieve satisfactory borehole development may result in rejection of the work and withholding of payment until corrective measures are completed. Defects and Liability The Contractor shall be responsible for any damage caused to the borehole arising from: Excessive compressor Poor Improper handling of Any such damage shall be repaired by the Contractor at no additional cost to the Employer. Special Instruction The Employer’s Drilling Coordinator or Technical Officer must be present during all airlifting activities. No borehole shall be developed, altered, deepened, or subjected to additional works without prior approval from the Employer’s representative. All measurements, observations, and development records shall be jointly verified and signed before site demobilization. Tender Bid Submission: from September 29, 2026 to October 9, 2026 Bidding Documents Required All bidders must submit: PDF Request for Quotation Fill in unit prices, any comments you have, and ensure detailed payment terms are indicated. Company Registration Documents Business Registration / Certificate of Incorporation Valid Tax Clearance Certificate Import/Export License (if applicable) Company Profile – describe goods/services specialization Three (3) References, preferably humanitarian/NGO clients Recent Bank Statement (not older than 3 months) Signed Supplier Code of Conduct & Tender Code of Conduct Official Quotation with: Unit prices Delivery lead time Payment terms Quote validity Minimum Requirements for Acceptance Suppliers must: Statutory Be legally registered in Liberia Hold valid tax clearance and required licenses Operational Capacity Operate from a fixed physical business location Demonstrate adequate staff, warehouse space, and stock levels Show proven experience with similar supply contracts Technical Capacity Provide correct specifications and evidence of product authenticity Demonstrate expertise in the relevant category Provide warranties and after-sales support (mandatory for technical items) Financial Capacity Show ability to supply large orders Provide recent bank statements Offer favorable payment terms (preference: after delivery) Price & Lead Time Provide competitive pricing and realistic delivery timelines Request for Quotation Documents – please send in an email to Submission Instructions: Your proposal/bid should be prepared in English (all supporting documents should also be in English or translated into English) Please fill in the Request for Quotation (RFQ) with the required information. No field should be left empty. Stamp and sign each page of the filled RFQ and all the documents received Email your bid to Use the Tender reference Number as the subject line of the email. Example: TNDPR- Please ensure you include all necessary documentation. Note that incomplete packages may not be considered for the award. Also, ensure your email size is LESS than 15MB. If sending multiple emails, please appropriately number each email (Example: 1/3, 2/3, 3/3, etc). You will receive an acknowledgement email if your bid was submitted correctly. Optional Hard Copy Submission: Samaritan’s Purse Office ELWA Compound, Paynesville, Monrovia, Liberia Closing Date: October 9, 2026 – 5:00 PM Liberia Time (Late bids will be automatically disqualified.) Important Notes Lowest price does not guarantee award. SP reserves the right to cancel, accept part of a tender, or reject any bid. SP may conduct site visits to verify supplier capacity. All submitted documents become SP property. The email subject line must be “TNDPR- . Please do not write anything other than the specific reference code in the subject line.” WE PRACTICE PROCUREMENT WITH INTEGRITY The integrity of the Public Tender procurement process is of the utmost importance. Unethical procurement conduct will not be tolerated and will result in immediate dismissal from the Public Tender procurement process. All bids are received directly by the Tender committee. It is not possible to influence the decision or outcome of the Tender. Submit your best value proposal for the first and only time. No Samaritan’s Purse employee will solicit you outside of this tender. If you, the supplier, suspect fraud from an SP employee, are asked to commit fraud or witness an SP employee act deceitfully, please notify Samaritan’s Purse leadership by calling our confidential hotline or email us at the following addresses. Email: Call or Text:

[Click the Apply button below to apply, and Create my CV to build a CV tailored to this offer, professionally]